(03) 9305 1400
Nylon sliding gate rack used for both domestic and commercial sliding & cantilever gates. Rated up to 700kg with 10×10 steel core to the centre. There are 6 brackets down mounting lugs with 25mm gap in-between, allowing for adjustability in-case of ground movement over time. The benefit of brackets down is it allows a the motor to be level or slightly higher than the gates bottom beam. The six bracing lugs allows for a higher load capacity on the rack at 700kg.
Please note, if rack is used on an incline or a heavy gate allow for a greater slow down (ramp down) time on each side. This can usually be programmed in the motors control board and is normally found in the manual under “slow down” or “ramp down” . This is to increase the a longevity of the nylon rack teeth as they tend to quickly wear away if a heavy or inclined gate where to quickly stop.
Contact us for price and availability on (03) 9305 1400
Stagnoli Sliding Gate Rack – N6
Stagnoli Sliding Gate Rack – S6
ART 43 Steel Galvanised Rack for Sliding Gates 22×22
ART 47 Steel Galvanised Rack for Sliding Gates 30×12 (slotted) & ART 49 Spaces